Zerostart 3600008 Replacement Cordset for Heavy Duty Immersion Heaters and Engine Block Heaters, 6-Feet | 120 Volts Zerostart & Temro

73 Customer reviews

Sale
$ 18 19
+


Product Description

  • Engineered and tested to withstand the extremes of temperature, moisture and vibration
  • Single heavy duty cord with male plug and silicone female connector
  • Works on heavy duty heaters
  • 120 volts; 6 ft. (1.8m); 16 gauge; Plug Type: 120 Volt, 15 Amp
  • Wire type: 16/3 HPN; silicone connector: right angle; pin distance: 0.360", pin diameter: 0.138"

Heavy duty immersion heater replacement cord.


Customer reviews(73)

Write Review
1_Deman
March 2, 2015
This is NOT a OEM cord made in Canada for the factory installed block heater on Mercedes-Benz vehicles but a sub standard Chinese made cord. The OEM cords had a fiberglass sheth and then wrapped with foil tape to protect the electrical cord from heat and abrasions or whatever may happen over time. This cord has none of those protection but it work well enough but if I would have been able to find the OE online I would have purchased that one.
Ray P. Lucero
June 8, 2018
My truck came with the element installed but no cord. How cheap can you be for a 50K ram diesel. This cord was added and now I have a block heater for my Ram. Easy to install and has worked with no issues
Phillip J.
January 12, 2017
Worked perfectly. I was planning to get the OE cord but did want to follow the exact route that the manufacturer did. The OE version is more expensive and comes with the push in prongs to secure the cord, which is nice, but you are limited on routing options. I have zips ties and they work great.
Jerry Stern
March 1, 2018
Fast delivery....Been using for about 4 weeks on and off. Easy installation, works as described. I added an 125v AC plug port and installed it on the front bumper for ease of use... Like the set up and would recommend it to all...
Mannyspd1
February 20, 2018
Fit perfect on my 2010 6.7 Cummins. Works like its supposed to. All these engines have the port for the heater and the heater built in...if you don't have the cord, this is what you need.
Matthew B.
October 18, 2016
Just installed on my 2008 2500 6.7 Cummins.
Getting ready for winter in the Eastern Sierra's. Haven't had to use it yet, truck does pretty well in the low temps.
The lows currently are around 22* F, but can expect to get down to 0* anytime soon.
I'm sure this will give her an Extra pep in her step on those Balmy mornings.
Customer
February 15, 2018
So far it works but is a wearable item from the heat. Be sure to insulated the wire with heat insulation when install in and around the exhaust manifold.
Mitchell Z
August 11, 2017
Works well just as expected. Easy to install and was the cheapest place to buy compared to others. Fit perfect on a 2007 Dodge 2500 5.9L Cummins.


Back to top